>> Blue Red
跳过导航链接home > Duplicator 3 Software
Duplicator 3 Software
WANHAO DUPLICATOR 3 SOFTWARE INSTALLITION
 
IMPORTANT NOTICE:
 
A. NEVER PEEL OFF THE YELLOW FILM ON THE HEATING BED WHICH ENABLE THE FILAMENT TO STICK TO IT. WITHOUT THIS FILM MAY CAUSE FILAMENT SKIDDING.
B. NEVER UNPACK THE NOZZLE INSULATING LAYER.
 
 
Procedure
  
     
This is optional choice. If your computer has already installed JAVA, go to procedure No.3.
CLICK THE JAVA LOGO TO DOWN LOAD
   
This software slice the 3D model into single printing layer which is called “Skeinforge”.
CLICK THE PYTHON LOGO TO DOWN LOD
 
This software accelerate the python speed.
 
  
 
Click to down load REPLICATORG 0040 edition.
 
 
Congratulations, you have finished software installation. Then you need to connecting computer to your printer.
 
 
1. Connect the serial port.
Start REPLICATORG and click Menu—Machine—Connection(serial port)—Rescan serial ports. If the printer still can not find the port, please go to step No.2.
 
 
If you find port, click the port.
 
 
Then connect the software to printer.
 
 
 
 
2. Navigate to equipment management- arduino mega. If your computer has orange exclamatory mark, please update the drive soft ware.
 
 
Lead the address to :"replicatorg_dir\drivers\FTDI USB Drivers”, then updating.
 
 
After updating drive, please RESCAN the port to connect your computer to the printer.
 
 
Choose the port the Replicator G scanned ad found.
 
 
 
 
3. Set Printer type.
Click Machine—Machine type—REPLICATOR DUAL.
 
 
 
Congratulations you have connected to your printer.