A. NEVER PEEL OFF THE YELLOW FILM ON THE HEATING BED WHICH ENABLE THE FILAMENT TO STICK TO IT. WITHOUT THIS FILM MAY CAUSE FILAMENT SKIDDING.
B. NEVER UNPACK THE NOZZLE INSULATING LAYER
This is optional choice. If your computer has already installed JAVA, go to procedure No.3.
CLICK THE JAVA LOGO TO DOWN LOAD
This software slice the 3D model into single printing layer which is called “Skeinforge”.
CLICK THE PYTHON LOGO TO DOWN LOD
For Duplicator 3 we recommend to use REPLICATORG 0027 edition.
CLICK THE REPLICATOR G LOGO TO DOWN LOAD
Congratulations, you have finished software installation. Then you need to connecting computer to your printer.
1. Connect the serial port.
Start REPLICATORG and click Menu—Machine—Connection(serial port)—Rescan serial ports. If the printer still can not find the port, please go to step No.2.
2. Navigate to equipment management- arduino mega. If your computer has orange exclamatory mark, please update the drive soft ware.
Lead the address to :"replicatorg_dir\drivers\FTDI USB Drivers”, then updating.
3. Set Printer type.
Click Machine—Machine type—THINGOMATIC W/HBP AND STEPSTRUDER MK7.
Congratulations you have connected to your printer.
After all the up mentioned steps, you can calibrate your printer.
Calibration is referring to the starting point. It refers to more specifically speaking that the distance between 3 axle stop switches to the starting point. ( The new printer has been calibrated before dispatching, customer don’t need to calibrate at first time usage).